Is here anywhere with instructions on how to remove the drivers side door panel to work on the window?

Thanks
Frank

Unscrew the lock knob
Pull the trim ring off the inside door handle
Remove 3 torx scews on arm rest
twist the rear of the arm rest up and slide out the power window switches and then unplug
Keep turning up the rear of the armrest until the front end releases
Remove the 3 plastic clips on the pocket by tuning with a dime
Push up on the pocket to release the top, then remove the top 2 screws.
The speaker will come off with the door panel, so no need to remove

Carefully pop all of the clips on the bottom and sides of the door panel. I use a thin paint scraper inserted between the panel and the door. Try to pry as close to the clips as possible, because it is very easy to rip the clips out of the cardboard. The bottom of clips will likely rip out because the door panel is often water damaged here. But this is not a big deal since the pocket holds the bottom on too.

Once the bottom and sides are unclipped push the door panel up to release.

Thanks so much for the help.

Frank