Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2007 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Removing bulb failure relay 200

posted by  pludodog on  Wed Jul 22 15:15 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Mar 22 12:15 CST 2010
[RELATED]

Trying to remove the bulb failure warning relay to fix a pin and reseat the connection. The orange cap immediately came off when I pulled, but everything else seems pretty stuck. Do I want to remove it above or below the black plastic washer next to the first circuit board? Am gently prying with a screwdriver, but leery of bending the pins, the whole unit seems fairly fragile.







  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Removing bulb failure relay 200

    posted by  TONY H on  Thu Jul 23 01:05 CST 2009
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Oct 17 16:39 CST 2014
    [RELATED]

    Teh black flat Washer is part of the Bulb Failure Sensor.

    I sent you some Pics to help clarify
    --
    '75 Jeep CJ5 345Hp ChevyPwrd, two motorcycles, '85 Pickup: The '89 Volvo is the newest vehicle I own. it wasn't Volvos safety , it was Longevity that sold me http://home.no.net/ebrox/Tony's%20cars.htm








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Removing bulb failure relay 200

    uid 18886's pic
    posted by  sdewolfe on  Wed Jul 22 16:50 CST 2009
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Mon Jan 31 05:56 CST 2011
    [RELATED]

    Howdy,

    Turn the BFWS so you can see the connector on the wire side. Looking at the wire side of the connector, in the middle, you should see the end of a tab, slightly off-center. That is the connector lock. That tab must be pushed toward the center to release the connector. Push the tab over with a thin screwdriver pushed between the tab and the connector while pulling back on the connector. The connector should come right off.

    If the cover came off in your hand, someone has already had it apart before you. If you find you cannot repair it and must replace it, I would like to have it. I will pay $5 plus postage for it. Contact me at sdewolfe-at-cricketlady-dot-com.

    --
    Mr. Shannon DeWolfe -- I've taken to using mister because my name misleads folks on the WWW. I am a 53 year old fat man. ;-)







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.