Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2013 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

How to replace the manual transimissin mount? 200

I have 1986 245 and the manual transimissin mount is bad. I searched and did find the procedure t0 replace it.

Do I need remove the cross member ? How hard it is?

Thanks for any input.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    How to replace the manual transimissin mount? 200

    got a grinder?

    to get more turning radius from your wrench grind out the useless material on the tranny mount bracket... you'll love it...

    http://s243.photobucket.com/albums/ff56/bigtahoe6/The%20Volvo/?action=view¤t=100_2394.jpg

    I've replaced 3 of these and I've removed the cross member every time cuz it's so much easier to just bolt the entire mount into the member, after the grinding aforementioned, it's as easy as changing oil.

    TIm
    --
    '92 244 NOW w/ M47 (Hydra, turbo bars, bilstein, urethane bushings)








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      How to replace the manual transimissin mount? 200

      One thing I know for certain about engineers - they are schooled to get the most bang for the buck regardless of the grade of work they are assigned to design. With that in mind, what useless metal did they forget to eliminate?

      Rich








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      How to replace the manual transimissin mount? 200

      Make sure the front mounts are good first. If they are soggy the whole unit can move backwards, making it very difficult to realign the mounting bolts. Also scary when you see how little is supporting everything.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    How to replace the manual transimissin mount? 200

    I did the one on my brother's '76, manual trans without pulling the cross member. Unbolt, jack up the back of the trans, slide new one in, tighten nuts.

    In any case, pulling the cross member isn't that difficult if you have to do it.

    Just make sure that thing is up on good solid stands before you get under it.

    Good luck

    Zimm








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      How to replace the manual transimissin mount? 200

      I find it easier to loosen the bolts for the cross member, it gives you more room to remove and install the mount.
      Dan







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.