Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2010 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

940 sunroof gasket 900


My 1995 940 sedan's moon roof had a thin black gasket drop out and can't figure out which edge it goes on.

It's just under three feet long, about a half inch wide, grooved eighth inch high.

My choices are the deflector, front edge of the glass, somewhere in the frame or the headliner door. Nothing seems like a perfect fit. It is completely intact, no breaks.

Unfortunately my 1994 has no hole in the roof, so I can't compare this time.

charlie

1995 940 185K
1994 940 160K









  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    940 sunroof gasket 900

    Tip the sunroof panel up at the back. Slide the headliner panel all the way back. Right where the headliner panel slides under the tray there is a metal strip along the front edge of the tray with a lip on top. The cross profile of the rubber strip is "h" shaped. The groove of the "h" sits over this metal lip with the tall part of the "h" toward the front of the car. You may want to tack the ends down with a little glue (like RTV or silicone sealant) if it won't stay seated.

    When I was cleaning out my sunroof the other week I noticed I'd dislodged the ends of that strip so I immediately knew what you were talking about.
    --
    Dave -940's, prev 740/240/140/120 You'd think I'd have learned by now








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      940 sunroof gasket 900

      Well darn, the same thing happened to me when I changed the gasket. I could not for the life of me figure out where the strip goes. Thanks, Dave. To the FAQ.
      --
      See the 700/900 FAQ at the drop-down menu above right.








      •   REPLY TO THIS MESSAGE    PRINT   SAVE 

        Have any of you guys replaced your sunroof seal? 900

        My new 92 745 has the sunroof seal coming loose from the aft edge of the sunroof. It appears that the felt part is seperating from the "U" channel part that clips onto the sunroof. It looks like it wasn't meant to be a seperate piece. I'm guessing a need a new seal. I need some idiot-proof instructions on the replacement.








        •   REPLY TO THIS MESSAGE    PRINT   SAVE 

          Have any of you guys replaced your sunroof seal? 900

          Yes, on two cars. See the FAQ: remove the sunroof panel (four screws on the sides), pull the old seal, pre-bend the new one to match the old one, install with the gap in the same spot. Use silicone to ensure it grips tightly and seals the gap where it meets. Reinstall panel and adjust so the rear is about 1/16 inch higher than the roof and the front about 1/16 lower. Total time about 90 minutes. It's also a good time to ensure the sunroof panel headliner is correctly adhering to the panel.
          --
          See the 700/900 FAQ at the drop-down menu above right.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.