Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2005

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Wrong intake manifold gasket for 240?

posted by  HM240 on  Sat Jan 3 17:26 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Mar 20 20:28 CST 2010
[RELATED]

Hi all,

I am replacing my heater hoses on my '87 240. New hoses are in and I am about to put a new intake manifold gasket in. The new gasket looks slightly different from the old one. The new one has an extra section of gasket material at the rear end, closest to the firewall. It has the eight bolt holes surrounding each intake, plus two larger apparently unused holes near the water pump. And the mysterious larger hole at the rear. The cylinder head has a big 19mm bolt where the hole is that I have been unable to remove. Does this bolt have to come out or can the gasket be trimmed?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Wrong intake manifold gasket for 240?
posted by  HM240  on Sat Jan 3 17:26 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.