Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Heater inlet hose. 200

posted by  pearl on  Mon Sep 24 23:29 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 7 09:41 CST 2009
[RELATED]

Like probably some of you, I'm using the Prestone Flush N' Fill Kit to back flush the cooling system before winter.
In attempting to follw the directions I'm asked to install a T onto the heater inlet hose. According tto the instructions on the back of the kit the inlet hose runs from the fire wall to the "top of the engine".
Per my exam of the 240 engine there's not a hose that does that. Are they talking about the long one which comes out of the fire wall and goes down by the power steering pump?
Should I use distilled water w/the antifreeze for the final fill?
Got any other tips for the task?
Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Heater inlet hose. [200]
posted by  pearl  on Mon Sep 24 23:29 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.