Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2017

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Error code 1-4-3 knock sensor always comes back, 93-940 -B230F

This check engine light started bugging me and the computer told me it was error code 1-4-3 (knock sensor at fault), I bought a new one and replaced it but the same error comes back every other week after clearing the computer memory so it should not be the same sensor again.

I have tried with different gasoline octane (87-89-93)and it seems to disappear when using 93 octanes although I am not so sure, besides, the car runs smoother, quiter with 87 octanes....and it's cheaper too.

Is this error code related to something else?? I plan to replace the ECT sensor just in case, with 210 Kmiles in its ribs it'll be good anyways.

B230F, non turbo wagon....runs great in general.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Error code 1-4-3 knock sensor always comes back, 93-940 -B230F

    carlos,
    i was having the same problem. from a tip through another person, i replaced my wiring with shielded 18 gauge cable with ground wire.

    i found a crack in my original wire insulation near the connector to the knock sensor, which probably shorted on occasion and caused the code to be thrown and caused my 940 to idle rough on damp mornings.

    i replaced the wiring last week and i haven't had any problems since.

    regards,
    byron golden
    86 245
    92 245
    94 940







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.