Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Injector question 745T '87 700

Picked up a set at the Pick and Pull from a 86 or 87 B230FT. Three were marked XXXXXXX357 (correct to '89) but one was XXXXXXX804 (listed for 90-92) Both have "green tops" but the 804 could be a little longer?

As dirty and cruddy as it was it certainly had been running with the oddball 804.

Is this an acceptable replacement or will I have a problem.

Resistance tests were good and spray patterns were visually OK.

I haven't searched the FAQ's yet








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Injector question 745T '87 700

I doubt you'll find anything in the FAQ.
I sent a set of each (I have LH 2.2 and LH2.4 turbos) to Cruizin Performance for blueprinting; in the end, the flow was the same for all 8.
My '87, however, idled better with the 357s. Don't know why.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Injector question 745T '87 700

You're right about the FAQ's but a search turned up just what you said! Not much difference unless you buy them new! $102 vs. $149 each.
Thanks







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.