So it seems everytime i need to replace a bulb or a fuse for the rear tail lights, it always triggers something else to fail, or fuse to blow, and more lights end of failing. All my lights were working fine the other day, I went through all the bulbs doing a regular check up just seeing if any needed to be replaced. One bulb needed to be replaced, so I did that and put everything back together. When i turned my car on my bulb failure light was still showing up. So i checked the fuses and they were all fine, none blown. So then i went through all the bulbs again to make sure nothing shorted or blew, but they are all fine.
Basically it seems everytime i need to change a bulb or fuse, more things go wrong and trigger almost all of the rear lights to not work, excpet the one in the rear window. Even though i went through all my fuses on the left drivers kick panel, and all the bulb are good, why is it still causing the break lights not to work when i press the breaks? I was thiking maybe its the circuit board that the bulbs are all connected too, but i checked both of them and they look good. any help is appreciated.
-Andrew
--
1990 240DL 190,566 miles