Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2020 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Need distributor part # 200

posted by  dobber13 on  Mon Oct 30 16:09 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 18 19:10 CST 2014
[RELATED]

Anyone know the OEM distributor part # for 85 240 ti B21 engine? Thanks for any help. I have had a problem with the timing marks moving as you watch the timing with a timing light.Also have a slight miss.If bearings are wearing out this is a simptom.Lookng for a replacment used if known to be good or reman.Thanks,Charlie








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Need distributor part # 200

    posted by  Ron J on  Tue Oct 31 06:29 CST 2006
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Oct 24 13:20 CST 2014
    [RELATED]

    Hi Charlie,

    My book show the B21ET and the B21FT only to 1984. I can give you the part numbers for those.

    B21ET Bosch number 0 237 003 027 Volvo number 12 76 701-8

    B21FT Bosch number 0 237 003 024 Volvo number 12 76 703-4

    Hope this will help,

    RonJ








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Need distributor part # 200

      posted by  hardknocks! on  Wed Nov 1 11:45 CST 2006
      Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
      last visit: Sun Oct 12 06:42 CST 2014
      [RELATED]

      hi all.
      my volvo spec book goes like this
      1985 turbo b-21f
      distributor
      bosch no..........0 237 003 024
      volvo p/n.........1276703-4
      impulse sender resistance.....0.95 - 1.25 kohm
      hope this helps
      book says check timing with vacume unit disconnected, air cond off.
      start engine and do not run it over 1,500 rpms (to avoid influence from spark control unit)timing 12 degrees plus or minus 2 degrees at 900 rpms.
      good luck
      mike
      --
      85 244 ti 222,000 83 244t broke odo, 85 244 19?,000 86 244 151,000 94 944 116,000








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Need distributor part # 200

    posted by  Trev29 on  Tue Oct 31 00:36 CST 2006
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Oct 17 05:56 CST 2014
    [RELATED]

    I thought electronic ignition compensated for worn distributors. That is a selling point for a points to EI conversion.
    --
    1980 245 Canadian B21A with SU carb and M46 trans in Brampton, Ont.








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Need distributor part # 200

      posted by  dobber13 on  Tue Oct 31 12:56 CST 2006
      Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
      last visit: Sat Oct 18 19:10 CST 2014
      [RELATED]

      TREV29,I can't think of anything else that would case the timing mark to do that.Like Porkface said it's not the harmonic balancer.I put a new timing belt and tensioner on and still have the same problem.Has anyone else run up on this problem? Thanks,Charlie








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Need distributor part # 200

    posted by  Jorrell on  Mon Oct 30 16:14 CST 2006
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Thu Dec 27 03:00 CST 2012
    [RELATED]

    Don't have an answer for your question, but have you checked to see if the harmonic balancer is worn out/slipping? This will make the timing mark do some really wild stuff!

    jorrell
    --
    89 244 171K miles, 92 245 241K miles, 06 XC70, 00 Eclipse custom Turbo setup








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Need distributor part # 200

      posted by  porkface on  Tue Oct 31 09:51 CST 2006
      Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
      last visit: Fri Oct 24 09:12 CST 2014
      [RELATED]

      fyi-this does not apply to the 85 240 turbos because they are b21s and use the old balancer setup. the slipping ocurs only on the the b230s. and so it goes, chuck.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.