Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2004 120-130 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

in need of new floor pans 120-130

posted by  mest on  Fri May 12 08:16 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Dec 9 16:53 CST 2010
[RELATED]

While preparing to install carpets, I discovered rust holes in three of my floor panels. I've located new front panels but the only rear oines I found will take 6 to 8 weeks to get here. I've tried VIP and VP products. Are there any other sources out there short of going overseas? Thanks, Mac








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

in need of new floor pans 120-130

posted by  walrus3 on  Fri May 12 15:09 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

Why don't you fabricate some patches from 16 or 18 gauge sheet arn?
--
George Downs Bartlesville, Heart of the USA!








  REPLY TO THIS MESSAGE    PRINT   SAVE 

in need of new floor pans 120-130

posted by  someone claiming to be Valve-O on  Fri May 12 16:12 CST 2006 [RELATED]


George,

what's "sheet arn" and where could one find it? I need to do some hole patching myself.







  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

in need of new floor pans 120-130

posted by  walrus3 on  Sat May 13 03:23 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

Go to your local sheetmetal shop. They'll know what it is.
(Okie pronunciation of "Iron", AKA Fe )
--
George Downs Bartlesville, Heart of the USA!








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

in need of new floor pans 120-130

uid 32173's pic
posted by  Gary L on  Fri May 12 16:34 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 10:26 CST 2014
[RELATED]

Sometimes you just have to excuse us Okie's... "arn" is how you would pronounce "iron" in Bartlesville. ;)

So... 16 or 18 gauge sheet metal (.060" or .048" thickness) is what you're after.

Gary L
--
1971 142E ITB racer, 1973 1800ES, 2002 S60 T5







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.