Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Oil Sender...Size? 200 1986

Can anyone tell me what size (socket or wrench) I'll need to R&R the oil pressure switch on a 1986 B230F? It appears to be the same as the injection temp sensor, but too deep for a socket...??

Thanks very much,
Brendan.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Oil Sender...Size? 200 1986

    Do not know the size, it will not be very tight, gentle knudge with pliers or vise grips? Crude but effective.
    --
    David Hunter








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Oil Sender...Size? 200 1986

      It is either 22 or 24 and a damn sight easier to get to if you pull the oil filter first. I have a special front end ratchet set that has these custome sockets that have flats on the outside of them and that is what I use to pull those senders, works slick as snot. If I had to bet one way or the other, I think it is the 24mm (15/16) socket and no it is not the same size as the temp sender, that should be a 19mm or a 17mm.

      Mark







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.