Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2008 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pulling out motor - it's time 700 1989

posted by  someone claiming to be Clayton on  Mon Apr 28 09:41 CST 2003 [RELATED]

Leave the trans in the car. Leave as much on the engine as possible, except the AC. Take the engine as a unit - much easier to assemble the manifolds on the stand than leaning over the fender. The harness can be pulled from the engine, or disconnected and removed with the engine. Its a toss up. The flexplate bolts can be removed easily with a deep offset 17 mm box wrench, 6 point best, 12 point OK.
Support the trans really well though.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Pulling out motor - it's time [700][1989]
posted by  Cisco  on Mon Apr 28 08:00 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.