Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: Need part# for rear dogbone bushing 200 90

posted by  someone claiming to be Jim on  Mon Nov 27 13:30 CST 2000 [RELATED]

These "dog bone" bushings are all the same. The IPD blue urethane ones go in with out a press. I'm sure they'll last alot longer.

These were the only ones that were "toast" when I checked all the rear end bushings. I've got an '87 with 155,000.

I got the IPD kit for the whole rear BUT you'll never get those big ones out of the rear end (axle housing) without a special tool. You can't very well carry this to a machine shop.

A while back I got a Brickboard "Red Star" for my question on how to get these mo fo's out. With all the posts I got, the only way is to beg, borrow, or steal the special tool.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need part# for rear dogbone bushing [200][90]
posted by  someone claiming to be Brian  on Fri Nov 24 06:47 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.