Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Crank Position Sensor had Failed 200 1990

Here's the latest, to various replies from ya'll. Ether sprayed into the small vacuum hose nipple consistently gets it to run smoothly for a few seconds till the ether is gone.
OBD DTMs 3 and 2 all check out fine, with lots of clicking and injector pulsing, and good test codes showing up.
The orange wire at the AMM shows power with the key on. Also the notorious 25a fuse and holder on fender well is flowing voltage no problem. Next???






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New No start situation [200][1990]
posted by  CLL  on Tue Apr 5 11:35 CST 2022 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.