1/8" plate?

To use two example images of the Left North American driver side motor mount (the smaller one the engine pulls on when revving):

What I believe to point (towards the engine bracket) up as the bushing mold has a seam around the circumference:


What I believe to point (towards the cross member bracket) down as the bushing mold has a seam around the circumference away from the camera (opposite side):


What is the 1/8 inch plate in the image?

The bushing is composed of two round, flat steel plates with the alignment pin and the threaded stud secure to the plate. Each of the plates are bound to the bushing material. There is a seal around the bushing material the hides the edge of the plate.

So, I probably confused as to what you mean.

Though install orientation become evident as you position the bushing into the upper and lower brackets each side. That is, if there is an orientation. It's been about four years I've performed this task.

Thanks,

Pinto Bean and Medical Device Boyeeeeeeeee
--
Give your brickboard.com a big thumbs up! Way up! - Roger Ebert.