Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replace banjo fitting at fuel filter - how? 200 1990

posted by  porkface on  Thu Oct 30 22:44 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:12 CST 2014
[RELATED]

the nylon line is a holdover from the kjet days-much higher pressure. this is about the only time and place a rubber FUEL INJECTION hose can be used. kjet runs at approx. 90 psi, lh about 50 or so. burst pressure is approx. 100 psi with rubber hose. wth the CORRECT hose, rubber is fine. good luck, chuck.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replace banjo fitting at fuel filter - how? [200][1990]
posted by  jon_h  on Thu Oct 30 21:36 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.