Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

replacing rear wheel seals and bearings 200 1990

posted by  transit wind on  Wed Mar 5 23:34 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 15 22:40 CST 2014
[RELATED]

To drive it back onto the shaft get a metal pipe longer than the shaft at Home Depot the same round size as the bearing. Then you can just pound the bearing back onto the shaft. Maybe this was mentioned before but didn't see it. You can take a long pipe and have the guys at Home Depot cut you a piece I believe about 3 feet long. I might of also bough a screw on cap to pound on the top with, can't remember.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replacing rear wheel seals and bearings [200][1990]
posted by  Jac912  on Wed Feb 26 06:13 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.