Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 140-160 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2025 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M41 front seal 140-160

uid 5322's pic
posted by  alschnertz on  Mon Jul 27 12:21 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:32 CST 2014
[RELATED]

"From a parts breakdown it seems to show a seal, gasket and O-rings for the three housing bolts. Is that correct?"

Yes.

"Do you just pull the bolts and replace the seal, gasket and O rings?"

Yes.

"Any chance the front shaft will fall out in the process?"

No, but still be careful anyway.

"While I'm at it how hard is it to change the front bearing. It seems quiet. Just leave it be?"

Technically, you can change it without disassembling the gearbox, but it would be super difficult. Much easier to change when you have the gearbox apart. My opinion is if it is quiet and you have no reason to think it's bad, leave it.

I have never had a problem installing the bell housing first and then the gearbox to the bell housing. Of course this is referring to a M4, M40, M41. Actually, I don't think I've ever done it any other way.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M41 front seal [140-160]
posted by  cef2lion  on Mon Jul 27 09:10 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.