Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 140-160 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2004 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

M41 front seal 140-160

posted by  walrus3 on  Mon Jul 27 10:46 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

I agree. I use a short piece of 3/8" alum wrench in a 3/8" socket and a 3/8"
drive extension.
That gives enough flexibility (with the tranny hanging down) to tighten it up fairly well.
Sometimes I finish the job with a regular alum wrench and a piece of 3/8" pipe or other suitable tube
as a cheater.
Do you think your front tranny seal is bad? Usually they last pretty well.
--
George Downs, Bartlesville, Heart of the USA!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M41 front seal [140-160]
posted by  cef2lion  on Mon Jul 27 09:10 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.