Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Dist. comp. 200 1983

Going out on a limb here.....

http://www.autohausaz.com/index.html

According to this site there were three different Hall Sensors/Senders used between 83 and 85. By their listing the round plug sensor was for the white cap distributor only. Bosch has 2 different ones depending on the 10 or 14mm shaft (both with rectangular plugs). The newer distributors have the thicker shafts if I am not mistaken.

Questions:

1. What is the diameter of the shaft of the white cap distributor?

2. If a newer distributor (with a thicker shaft) is installed in an older block, what are the chances that the drive gear on the bottom would be slightly different than that on the thinner shaft?

3. Could such a difference cause the timing to not be steady thus making the hall sensor wonder WTF?

4. Would the distributor and intermediate shaft possibly need to be mated from the same model engine?


--
Harold Thompson '84 245 Virgos






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New changing 1983-84 L2.0 to L2.2 (85-8?) [200]
posted by  transit wind subscriber  on Tue Mar 31 06:54 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.