Click on the picture image to send the IMAGE URL back to the referring screen.
Display by picture type:
[
CARS(default)]
[
PERSONAL]
[
TECHNICAL]
[
CLASSAD]
[
STANDBYV]
|
Welcome to the gallery. All exhibits are volunteered by users.
There are 14003 total exhibits.
|
|
[ADD A NEW EXHIBIT]
|
|---|
Search criteria: pix_type=TECHNICAL. [
CLEAR]
Showing 401 through 420 of 14003 matching exhibits.
<< <prev 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 next> >>
|
|
|
| POSTED BY |
| Dom's940[SHOW ALL] |
| DATE |
|
| HTML |
|
| CITY |
| Laurel |
| STATE |
| DE |
| COUNTRY |
| US |
| NOTE |
| cleaning the passenger side switch. |
|
|
|
|
|
|
|
| POSTED BY |
| 1908242DLa[SHOW ALL] |
| DATE |
|
| HTML |
|
| COUNTRY |
| US |
| NOTE |
| I repacked my wheel bearings less than 1k miles ago and did not see any damage on the wheel bearing race (right term). However, I've been hearing a slight rumbling. On removing the hub, I noticed gouging at the 6 O'clock position, as shown this photo. The inner and outer bearings have no blemishes, but the inner bearing was stuck to the axle. |
|
|
|
|
|
|
|
| POSTED BY |
| whitedavidp[SHOW ALL] |
| DATE |
|
| HTML |
|
| CITY |
| Clinton |
| STATE |
| WA |
| COUNTRY |
| US |
| NOTE |
| Using foil duct tape, which is pretty amazingly good stuff - perhaps not for this application but... |
|
|
|
|
|
|
|
| POSTED BY |
| whitedavidp[SHOW ALL] |
| DATE |
|
| HTML |
|
| CITY |
| Clinton |
| STATE |
| WA |
| COUNTRY |
| US |
| NOTE |
| And maybe from here too? |
|
|
|
|
|
|
|
| POSTED BY |
| whitedavidp[SHOW ALL] |
| DATE |
|
| HTML |
|
| CITY |
| Clinton |
| STATE |
| WA |
| COUNTRY |
| US |
| NOTE |
| With the tail light assemblies and my masking removed, I noticed more of what might be splitting in body panels. Thought I had this masked off though. So would not guess water would get in here. |
|
|
|
|
|
|
|
| POSTED BY |
| whitedavidp[SHOW ALL] |
| DATE |
|
| HTML |
|
| CITY |
| Clinton |
| STATE |
| WA |
| COUNTRY |
| US |
| NOTE |
| The lack of this special reflector (or whatever it is) is the only difference I can find between the very expensive Bosch US tail light assembly and the non-US Bosch assembly. Perhaps technically not correct. But really? Have to pay at least twice as much to get this? |
|
|
|
|
|
|
|
| POSTED BY |
| muskox37[SHOW ALL] |
| DATE |
|
| HTML |
|
| CITY |
| PARKSVILLE |
| COUNTRY |
| CA |
| NOTE |
| This is the aft end of the motor. Can it be pulled apart successfully? |
|
|
|
|
|
|
|
| POSTED BY |
| whitedavidp[SHOW ALL] |
| DATE |
|
| HTML |
|
| CITY |
| Clinton |
| STATE |
| WA |
| COUNTRY |
| US |
| NOTE |
| Not sure what this is or if it could actually allow water into the trunk. |
|
|
|
|
|
|
|
| POSTED BY |
| whitedavidp[SHOW ALL] |
| DATE |
|
| HTML |
|
| CITY |
| Clinton |
| STATE |
| WA |
| COUNTRY |
| US |
| NOTE |
| I noticed this and cannot help but wonder if this could be a crack allowing water into the trunk? It is located above the tail light assembly. |
|
|
|
|
|
|
|
| POSTED BY |
| whitedavidp[SHOW ALL] |
| DATE |
|
| HTML |
|
| CITY |
| Clinton |
| STATE |
| WA |
| COUNTRY |
| US |
| NOTE |
| As indicated, there was some puddled water where indicated and signs of water along the seam right of the tail light hole. |
|
|
|
|
Search criteria: pix_type=TECHNICAL. [
CLEAR]
Showing 401 through 420 of 14003 matching exhibits.
<< <prev 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 next> >>
©Jarrod Stenberg 1997-2022. All material except where indicated.
Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)