Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2015 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

how to read codes on a 95 850...link please 850

posted by  Jeong on  Wed Oct 16 10:20 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I replaced one in a '94 850 on the passenger side before. It started making some noise so I just replaced it. The part isn't too much ($50 or less)and I purchased it from Swedish Engineering. I would just replace it and be done with it. The procedure is fairly straightforward.

-Just remove the grab handle by removing two screws on either end covered up by plastic hinges.

-Remove plastic cover for sensor/fan.

-Remove plastic molding on A pillar.

-I think you'll need a small 10mm combination wrench to get the fasteners off the sensor and some patience as the space is tight.

Good luck.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New how to read codes on a 95 850...link please [850]
posted by  someone claiming to be Robert  on Tue Oct 15 08:37 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.