Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2004 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

850 hood bracket bent 850 1996

posted by  someone claiming to be tucker on  Sun May 29 01:25 CST 2005 [RELATED]

I caught a tiedown on the back left corner of the hood (in front of steering wheel) and pulled the rear corner of the hood up about an inch or so. Hood closes ok but corner juts up about an inch. Have thought about replacing bracket because i can see it is bent.
How much trouble is it to replace? Does quarter panel have to come off for this job? Is it a pain to get it all lined up again? It is a ten year old car and I have better things to do with my time and money but the challenge is there and hard to resist.
Any suggestions?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 850 hood bracket bent [850][1996]
posted by  someone claiming to be tucker  on Sun May 29 01:25 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.