Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2017

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Upper Motor Mount - Urethane vs Volvo Rubber??

posted by  WatsonMD on  Fri Oct 15 03:12 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I've been having a knocking sound when doing highway speeds and turning to the right. Went over everything. Think I've finally found the culprit - upper motor mount it busted. This is on a '97 854 GLT with 74K.

I've searched and read all the related threads. The urethane seems to be the easiest to replace (remove old, bolt in new). But, some complain of new engine vibration felt in the interior. Is it bad/noticable?? Something that you get used to?? Any input would be helpful.

The original volvo rubber bushing seem to be a bit more painful to put in - but no vibration.

So what is the overall consensus. Any/all opinions are greatly appreciated.

Andrew






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Upper Motor Mount - Urethane vs Volvo Rubber??
posted by  WatsonMD  on Fri Oct 15 03:12 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.