I was driving the 96 850GLT (110,000 miles) in town this morning when it felt and sounded like I lost a cylinder. The Check engine light started flashing and the engine continued to run rough with a noticeable miss. Then about twenty seconds after it had started, the check engine light went to steady on and the miss went away. I have driven the car three or four times since the miss and the car appears to be running normally. Starts right up and does not appear to be short any power.... The check engine light will not go out.
As it turned out, the Check Engine light did go out by itself the following day, but the OBDII found two codes: P0305 Misfire Cylinder 5, and P1310 Unidentified. I have cleared both codes and decided that a piece of carbon must have shorted the plug in cylinder 5. The plugs, wires, cap, rotor, flame trap, and fuel filter have all been replaced in the last 5,000 miles.
What does the P1310 code mean????
Thank you in advance
Oliver
|