Volvo AWD V70-XC70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2004 V70-XC70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

balljoint/control arm installation question V70-XC70 1999

posted by  philvo on  Fri Feb 20 08:47 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 15 14:26 CST 2014
[RELATED]

I am a RWD volvo shadetree mechanic and I was doing some suspension work on a friends V70.I replaced the stabilizer links and tie rod ends no problem but got hung up doing the control arm/ball joints.The pinch bolts on both sides were siezed up pretty good.I was able to free them up w/PB Blaster and drove them out with a hammer and drift.Also is the balljoint supposed to "pop" in to the steering knuckle,I got the control bolts on and then put a jack under the balljoint and lifted it until it was flush with the rubber boot and then tighened the pinch bolt(it didn't fall back out,so I guess it's in OK).The front end was 100 percent tighter after my 4 hours of labor.I took the car for a road test and the steering was tracking fine but I did recommend an alignment.
Nice car,first time I ever drove a FWD volvo.I have had a dozen RWD models from '67-'90.
--
philvo '86 245 215k,'90 240 196k,'87 SAAB 900 SPG 213k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New balljoint/control arm installation question [V70-XC70][1999]
posted by  philvo subscriber  on Fri Feb 20 08:47 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.