Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2004 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Tips for pipe flange bushing press for upper torque arm? 850 1996

posted by  daveh on  Sun Apr 28 03:44 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Anybody got any tips for pressing the OEM bushing in for the upper torque arm on a 96 850? I'm using the pipe flange technique posted here previously (see link below), but the bushing keeps popping out of alignment and I can't get it started. I've wet it down w/ soapy water to help lubricate, but still no luck. Anybody been able to use this homemade press? Don't bother suggesting the IPD bushing- been there, done that- too much vibration.

http://www.brickboard.com/AWD/index.htm?id=135198&show_all=1

Thanks,
Dave H.
93 854GLT
96 855






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tips for pipe flange bushing press for upper torque arm? [850][1996]
posted by  daveh  on Sun Apr 28 03:44 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.