Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2012

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Axel Shaft Failure?

My 01 V70 T5a with 105K miles is starting to make an unusual "grinding" noise when going around a sharp turn with a bump. If the turn is level no noise. I did an oil change this weekend and rotated the tires. While they were off I grabbed the CV joints and wiggled. On both sides, the inner joint seemed to have just a very little bit of play. I have been noticing this more on left turns, so I figured one side would have a little more play. They both felt the same. Are both going bad, or am I on the wrong trail?

I noticed FCP Groton and IPD both sell DSS brand. Are these OEM, or should I go through a dealer? Any things to know when changing these out? I thought it shouldn't be too tough. Oh, I did check the spring seats too and they still seem good.

Jerry






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Axel Shaft Failure?
posted by  checksix subscriber  on Sun Jan 17 17:05 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.