Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2009 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

steering gear pinion gasket reneval, sub frame bolts and nuts? 850 1994

posted by  tom 240 on  Mon Aug 4 00:35 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jun 17 18:20 CST 2009
[RELATED]

Hi, my 850 -94 with 225kkm has been leaking a bit at pinion for some time.
I finally decided to renew the pinion upper gasket (30 Euros) to make it to end. It was quite a job to remove and install but Bay13/power_steering.pdf was good help in doing this. So I have got all back again and not yet leaking.
Full steering gear renewal would have costed around 1000 Euros.

I remember reading somewhere that one should renew all bolts and nuts used for fixing the subframe again - is this really necessary? or at the end of tie rod?

I also flushed the transmission and went over to mobil atf shc with Magnefine in line filter (from mobil atf 220)after about 50k miles and must say the old oil looked really bad even not experiencing any malbehavior of the tranny yet.

br Tapsa





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New steering gear pinion gasket reneval, sub frame bolts and nuts? [850][1994]
posted by  tom 240  on Mon Aug 4 00:35 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.