Volvo AWD S80 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2021 S80 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Software upgrade required with new MAF installation? S80 2000

posted by  someone claiming to be S80S80 on  Wed Aug 29 16:06 CST 2007 [RELATED]

Hi -

I just replaced the MAF sensor (also referred to by some as the AMM) on my 2000 2.9 S80. I replaced it because of a surging idle and CEL that was throwing codes p1171 and p1181. The car has about 96K on it.

The replacement seemed to do the trick - no more surging, CEL is off and no more codes. But, I've noticed a couple of things since replacing the part:

1. I'm getting an occasional clunking from the transmission upon acceleration that wasn't there before.

2. The throttle feels smoother and more consistent, but it also seems like the car has lost a bit of power.

My question - the part (bought from a local dealer) came with an orange paper in the box that stated new software must be downloaded with the new MAF (software is part number 9499307). I am going to get this done the next time I visit the dealer, but I was curious if not having the most up to date software might be causing these issues. Note - I have already had the ETM software upgrade performed (part number V030785453-9).

Thanks...






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Software upgrade required with new MAF installation? [S80][2000]
posted by  someone claiming to be S80S80  on Wed Aug 29 16:06 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.