Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2003

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Clamp or special tool to push in rear caliper pistons 850

I need to change my rear pads 2 months from now. Should I pick up some kind of tool by lisle or KD or just use clamps. I could spend up to $50 if it makes my life easier.
steve








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Clamp or special tool to push in rear caliper pistons 850

    I used a very large screwdriver and gently pried against the outer most edge of the rotor (on an angle), being careful also not to damage the gasket on the piston with the blade. Worked fine and I could have reused rotors if I had wanted to. You can place an old pad back and pry against that also once you have one piston compressed. It is really pretty easy.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Clamp or special tool to push in rear caliper pistons 850

    I have been using the same set of big channel locks for the past 20+ years and have never been left wanting because of them. The only one that you really need a special tool for is the S/V40 rears.

    Mark







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.