Volvo AWD S70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2002 S70 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1998 Volvo S70 T-5 Missing on cylinders 2 and 5 S70

I had scan tool hooked up to the car after the check engine light came on and it said it was mis-firing on cylinder 2 and 5 more than once. Before the check engine light came on I had replaced the spark plugs and gapped them correctly with Bosch platiums - because I felt is was misfiring. After the scantool gave me the misfire reading, I replaced the wires, cap and rotor, timing belt, and drive belt. It still misfires. What do I do now? Thanks








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    1998 Volvo S70 T-5 Missing on cylinders 2 and 5 S70

    Had a similar problem, put the plats in, along with a new bosch cap & rotor, CE light came on, misfire codes. Everyone told me to trash the plugs and put in OEM copper, so I did, light came back on. For kicks I replaced the cap and rotor again, never reset the light, but in 2 days it went off on its own.... Bottom line, I've read a number of posts on other board about plat plugs causing the CE light to go on.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    1998 Volvo S70 T-5 Missing on cylinders 2 and 5 S70

    Say a few prayers and hope for the best! How many miles on this bad boy?







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.