Volvo AWD S80 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2003 S80 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

error code help S80

posted by  mny1dxo on  Sat Jun 11 05:26 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 22 19:42 CST 2012
[RELATED]

Pulled the following code P0101. Waht does that mean?








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

error code help S80

posted by  iktew on  Mon Jul 18 11:45 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

according to vadis

Condition

-engine speed (RPM) 1,500–2,500 rpm
-throttle opening 7–30° (however no large changes with the accelerator pedal (AP))
-speed 50-110 km/h
-engine coolant temperature (ECT) between 80-110°C.
The desired value for mass air data is drawn from a table. It is applied with the actual atmospheric pressure and inlet intake air temperature (IAT). Diagnostic trouble code (DTC) ECM-130A is stored if the control module registers that the difference compared to the actual mass air is too great for approximately 5 seconds.


Substitute value
A calculated value from the pressure sensor for the intake manifold and engine speed (RPM) is used.


Possible source

Faulty signal
-Faulty mass air flow (MAF) sensor.
-Contact resistance in the connectors.
-Defective fresh air intake hose.


Fault symptom[s]
None.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.