Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2023 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

jack stand points front end 850 850 1995

I am going to replace my half shaft, and while I have never used a jack stand on a car, this seems like a great time to start (envision lying on back trying to pry and pull shaft while under car). My question is, what would be an appropriate place to jack/support the front corner. There is a squarish section of the chassis under the transmission that the control arms attach to that looks like a good candidate. The control arms attach to the two sides that parallel the axis of the car, and two run perpendicular creating the square (is this called the a-frame - it looks square but the sides may taper in). Can I pick any spot along these members to support the corner? TIA Don








  REPLY TO THIS MESSAGE    PRINT   SAVE 

jack stand points front end 850 850 1995

http://www.volvospeed.com/Repair/jackingpoints.htm
--
1995 850T Wagon 120k








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

jack stand points front end 850 850 1995

Sweet. I was over there looking at some other items but I hadn't seen this page. Thank you.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.