hello friends,
how do i replace my blower motor resistor? i was informed mine is bad since blower runs only on high speed w/c is way too much and might eventually do the blower motor itself. tried bay 13 but they were not clear?
thanks

If you have the Electronic Controlled A/C system the fan speed is controlled by the ECC box there in the dash, there's no seperate resistor to replace. I sent you the troubleshooting guide for the A/C system to help explain it better. See if you get any DTC fault codes when you test the B1 Socket under the hood.




Mike
'95 850T

thanks for the reply. my unit is the standard one, not electronic that's why i know it's the resistor?
thanks again

Oh Ok. In that case it's just to the left of the blower motor itself. Its that flat thing with a plug on it and two screws holding it in. Have to remove the glove compartment to get to it. Not hard to change. If you get a new one the old one will be very obvious to you when you look at it.



Mike

got it, thank you so much