Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2005 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

passenger side airbag cover 850

the cover for the airbag is peeling back slightly in the corner, what is the best adhesive to use to reglue the cover down. also, what's the best stuff to use for gluing down the side rubber trim on the doors.
--
94 855








  REPLY TO THIS MESSAGE    PRINT   SAVE 

passenger side airbag cover 850

my 93 did the same thing, the only thing that would hold was pvc glue,

worked like a charm, I only glued the dash area peeling up around the
air bag cover not the air bag cover it self,

also 3m makes a good automotive gule for plastics

good luck








  REPLY TO THIS MESSAGE    PRINT   SAVE 

passenger side airbag cover 850

I saw a post on this site to use clear silicone adhesive. I did this (G.E. adhesive/sealant)in the fall, and it has been holding ever since. It doesn't look as it did brand new, but it looks considerably better. Apparently, Volvo used an enviornmentally friendly adhesive and the holding power doesn't hold as well as it should. It beats paying $160.00 for a new cover. Good Luck...







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.