Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2008 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Strip above windshield 850 1997

There is a plastic or rubber trim piece above my winshield (exterior) that keep coming loose in the middle. I can slide it back in place, but then it comes loose again in a few days from wind. Anyone have a solution?








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Strip above windshield 850 1997

I lost mine, so I had to buy a replacemnet for $30 at the dealer. I used a small strip of clear silicone caulk to the whole strip and is holding good.
--
'88 240, '92 740, '98 v70 GLT John in Tampa Bay








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Strip above windshield 850 1997

Had the same problem. I bought a bottle of "Pliobond" at the local Ace. It's a great adhesive and is all weather. Brush some to the area that keeps coming off and push the trim piece back in the slot between the window and frame. The stuff is a bit messy but well worth it. It's a good all purpose adhesive to have in the garage too.

Good luck







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.