Volvo AWD S60 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2021 S60 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

2002 PVC Replacent-Banjo Bolt question S60

posted by  jchiodi1 on  Fri Aug 12 05:48 CST 2022
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Mar 11 07:42 CST 2013
[RELATED]

I've watched many YT videos on this procedure. All seem to gloss over the part about this 17MM bolt re-install! It seems to require at least 4 hands to do this! I have the intake loosely installed and I am trying to get this bolt lined up and it is defeating me.

I did replace the hose connecting the fitting that the bolt goes through, and it seems to put the alignment slightly off. It's very hard to determine exactly where that fitting should be with the intake off..


I've removed the radiator and even the core support but there is still little room to get hands on that fitting, turn it to line up, and start it in. Do not want to take a change of damaging the threads.

Any thoughts about this? I haven't tried to pull the intake back off and do this because it seems the hose might not have enough "give" with it being connected to the PVC.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 2002 PVC Replacent-Banjo Bolt question [S60]
posted by  jchiodi1  on Fri Aug 12 05:48 CST 2022 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.