Volvo AWD C70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2024 C70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

2012 C30 rear camshaft cam sensor plate Removal C70 2012

posted by  jorrell245 on  Fri Nov 29 15:56 CST 2019
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 13 22:04 CST 2014
[RELATED]

Gentlepersons,

Just picked up another C30, a home mechanic's C30 for a song. 115K on it but alas, his timing belt swap was a semi disaster, yes, I'm looking at replacing 10 or 20 valves, not sure which yet. This is the B5254T7 engine. So, how does one get the cam timing cam plate off the end of the camshafts that are used for the cam position sensors?

I tried the T30, wouldn't fit, went to the T27 Torx and tried removing the center bolt counter clock wise. That sucker wouldn't budge right up to where the T27 snapped.

I'll take any ideas as I'd like to find out if it is 10 or 20 valve bent so I can decide between a new used head or rebuilding this one. I should be able to use the cam lock tools once that sensor cog is off the end of the shafts.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 2012 C30 rear camshaft cam sensor plate Removal [C70][2012]
posted by  jorrell245  on Fri Nov 29 15:56 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.