Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2014

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Head Gasket Slots

Hi, I am a little confused.
I searched a B5244T3 engine head to check compatibility with my B5254T engine head with an eye to replace. IPD USA list a gasket for the B5254T which is the same as a B5244T3 has. That is good. I also bought a set from FCP for my B5254T which contains the gasket with fewer slots.
However, Swedish Parts site has extra slots in their B5254T gasket select. Another site also has the gaskets with two or three extra slots in it for the B5254T. On my actual car block are extra slots.
Am I going to encounter problems if I use the one with fewer slots on my B5254T block? Also, what is going on?









  REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

and then I see the actual B5244T3 engine that I want to get and there are more slots like the B5254T!




Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.





  REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

It's strange too that I had exhaust manifold pieces on my car like the set in photo on right.




Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.




<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.