Volvo AWD S80 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2003 S80 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Question about replacing engine mount on top of engine. S80

The large, circular engine mount (bushing) located on top of the engine that attaches to the large black stabilizer bar that runs between the shock towers is shot and needs to be replaced.

My question is...is it necessary to also replace the two bushings on either end of the stabilizer bar? There is "some" wiggle in the bar when I rock it back and forth (fore and aft) but that might be normal? I took the bushings out to look at them and they seem intact, i.e., the metal collar has not separated from the rubber part.

Any input appreciated. Thanks.
--
2001 S80 2.9 (non-turbo), 128K miles








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Question about replacing engine mount on top of engine. S80

My opinion is not to change those two bushings. They are suppose to wiggle. Save your money.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Question about replacing engine mount on top of engine. S80

You are correct. The mount bar will have some "slight" movement on the strut tower. Changing out this torque mount is one of the easiest repairs I did to my s80. IIRC, took about 5-10 min.

Lane







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.