Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2012 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replacing antenna mast 850 1995

My power antenna decided to crap out the other day, lots of noise but no movement. I remember doing this once on an old 240 DL I once had and it seemed pretty easy. Do I just loosen that nut on top of the rear fender and then pull out what is left of the plastic gearing? Also wondered if there is a way to check inside the antenna motor for broken pieces of the plastic gear teeth?








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replacing antenna mast 850 1995

The fender nut is the only thing holding the antenna down, besides a cranky stainless steel sleeve. Just check the end of the plastic toothed strip to make sure it is all out. They seldom break apart. And remember which way the teeth are pointing when you pull it out! The new one goes down in the same direction.

I have had the motor out and completely disassembled. There are a few hard fitting pieces inside the round part, but re-greasing helped get rid of the noise I was having.

Klaus
--
I still miss my 164 and my 854T. Just driving a V70R :)







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.