Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2002 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

water pump gasket 850

I am replacing the water pump and gasket on my 97 850. Should I use gasket cement?

thanks bob








  REPLY TO THIS MESSAGE    PRINT   SAVE 

water pump gasket 850

Yes, use a little of your favorite gasket cinch on the pump side only. I have been using 3M spray adhesive for the past 20+ years with no problems but most anything will work. The glue is not there as a sealant, it is there strictly to hold the gasket in place while you assemble it. If you put some on the engine side it will make the next pump a bitch to do.

Mark








  REPLY TO THIS MESSAGE    PRINT   SAVE 

water pump gasket 850

Hi,
last summer I renewed 850 -94 timing belt, rolley, tensioner and water pump at 200kkm as secont tbelt renewal was due. the water pump gascet was old paper type so I used similar delivered with the new pump, put some crease on both surfaces ie old style. I think cleaning off all old rests is most important.
Is working fine.
br Tapsa








  REPLY TO THIS MESSAGE    PRINT   SAVE 

water pump gasket 850

Thanks for the advise. I will use the 3m stuff.

bob







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.