Volvo AWD S70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2005 S70 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

S70 side moulding S70

posted by  someone claiming to be jimbob on  Tue Jan 31 04:22 CST 2006 [RELATED]

I had the misfortune to damage my passenger and rear passanger doors and I need to take for repair. I read the estimate from the body shop and they talk about double sided tape for the side mouldings. I would like to know how to remove the side mouldings myself so I can reinstall them myself after the doors are repaired. thanks jim








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    S70 side moulding S70

    posted by  KlausC on  Tue Jan 31 14:40 CST 2006
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Oct 24 10:15 CST 2014
    [RELATED]

    My 95 and 98 have side mouldings that are not taped on. Open the door and at the moulding level there is a little grommet. Pull it off, and look for a small torx screw that hold on the last clip. I dipped my torx driver in axle grease so that the screw would stick to the driver and not fall down inside the door and never to be seen again. Then the moulding can be pushed forward or backward, I forgot which, and it comes right off. Both doors are line that. The little one on the front fender pops off.

    Klaus
    --
    (V♂LV♂s 1975 164, 1995 854T, 1998 V70R)







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.