|
I think that the back seat bottom is held by a clamp that looks like half a ball with an inverted T-shaped slot cut into it.
To unlatch the bottom of the seat, you push on the bottom of the seat frame to move the wire that holds the seat bottom back into the enter of the T, then pull up.
If you push too hard, you push the wire into the back of the T and the seat bottom will not release.
The technique is to push the bottom of the seat frame back while pulling up - push back gently at first, then apply more force - when you reach the center of the T the seat bottom will come up.
It may take a few tries, but once you get the trick the seat bottom comes out easilly.
|