The Brickboard

BrickBoard Archives

The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.


Re: High Mileage Badges[240-260/82/83] posted by Paul S. on
Thursday, 7 May 1998, at 9:01 a.m.

Hi Chuck,

Read this through - I'll try to be brief:

Buy some fresh hi grade epoxy. Buy two appropriately sized (long enough to go through the grill) flat head machine screws with huge fender washers and nuts.

Clean the back of the badge (leave the double sided tape in place) and the flat head portion of the screw. Scuff both up with some emery paper. Clean 'em again. Mix the glue. Glue the screw heads to back of the badge on the two "winged" areas.

Let the glue cure overnight or more. Test position the badge on the grill. Peel back the double sided tape cover. Stick the badge on. Put the "warshers" and the nutz on and cinch 'em up a bit to squish the double sided tape.

Make any sense?

Still holding strong for a year. --
Paul S. (Mr. Project 245T)




 


©Jarrod Stenberg 1997-2016. All material except where indicated.



Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

Powered by Denizen Motive Forum - Custom Software for Volvo Enthusiasts