The Brickboard

BrickBoard Archives

The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.


Re: tranny shudder in 122[122/1964] posted by George Downs on
Saturday, 2 May 1998, at 7:07 a.m.


The red seals used on later B20 and B30 work great, gotta
eithier have a modified seal carrier or one from a later model.
IPD modifies and sells updated old ones exchange.

Shudder is aggravated by soft engine/tranny mounts,
which are a very common problem especially if you have
oil leaks. If I were you I'd replace all 3 mounts unless
they are obviously new or near-new. --
George Downs Fort Clayton, Panama


Re: tranny shudder in 122[122/1964] posted by Brian T. on
Saturday, 2 May 1998, at 11:10 a.m.

George is right. You should know that the rear seal in your engine is probably a simple old felt seal, and putting a new felt seal in it will not stop the leak if the engine has excessive blow-by or your PCV system isn't working properly (I don't remember if '64 has PCV or not). Converting to a "lip" type seal would be better if you have a lot of blow-by.---Brian




 


©Jarrod Stenberg 1997-2016. All material except where indicated.



Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

Powered by Denizen Motive Forum - Custom Software for Volvo Enthusiasts