Quantcast
RWD - Question - Installing new head lamp on Volvo 240

Volvo RWD 200 Forum

INDEX FOR 8/2019(CURRENT) INDEX FOR 3/2006 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Question - Installing new head lamp on Volvo 240 200

I just received new genuine head lamp assembly. It contains front portion (lens and bulbs, etc.) and back plastic plate. For the right side lamp, the back plate contains three long adjustment screws (#9 in the diagram for example). The end of this screw is a round ball. This screw is clipped into the plastic housing(hole) area and by a clip on the plastic, which is the part of the front portion. On the diagram, the clip is #11.

Here is the picture.
https://www.volvopartswebstore.com/showAssembly.aspx?ukey_assembly=243136&ukey_product=1136022

My question is: should I remove the clip first and then push in the adjustment screw and then reinstall the clip? To do so, I think I need to force the clip back in with a meticulous picking tool and with some force. (If so, what tool do you suggest? The area is very tight.)

Or can I just push the back plate to the front part and simply have the adjustment screws into the holes and the clips will be automatically clicked in? (It does not appear to be. I am afraid to push harder.)


Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Question - Installing new head lamp on Volvo 240 [200]
posted by  sparro  on Tue Jun 11 07:59 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts