Quantcast
RWD - Replacing The Ignition Switch Cylinder 1993 240 5 Speed

Volvo RWD 200 Forum

INDEX FOR 8/2019(CURRENT) INDEX FOR 1/2006 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Replacing The Ignition Switch Cylinder 1993 240 5 Speed 200

Dan, the casting where the pins are is 3.5mm thick. The knurled pin is 3mm in diameter and 5.5mm in length.

I used a Dremel EZ Lock #456 metal cutting wheel to dig it out. I have little faith someone could do this from under the dash if over the age of maybe 30. If at all. Yet I understand getting it out of the airbag car is no easy or simple task. I'm newly impressed by the security these old Volvos had.

--
Art Benstein near Baltimore

My luck is so bad that if I bought a cemetery, people would stop dying. - Ed Furgol






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing The Ignition Switch Cylinder 1993 240 5 Speed [200]
posted by  pageda  on Sun May 19 15:55 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts